Home

Saturday, May 7, 2016

DIY Magnet Board

Delys and I are in the process of re-decorating a bedroom for her daughter, and one of the things that it lacked was a place to display favorite photographs and art projects. So I took a large, framed print that hung over her bed, removed the backing, took out the print, and threw away the glass. I carefully worked around the screw eyes and wire that we used to hang the picture so that we could use them again. (I wish I had taken a photograph of the original framed picture, but I thought about it too late.) With the same chalk paint that I bought to refinish her dresser (link), I painted the frame with two coats of paint, allowing the paint to dry thoroughly between coats, and then applied a thin coat of wax.

Then I made a quick trip to Lowes and purchased a 24 x 36" sheet of metal that I had seen in the plumbing department on a previous visit. (It cost $9.99.) Our frame is 24 x 30, so I used the print as pattern, drew on the metal with a sharpie, and then cut it to size with tin snips.

I smeared a liberal amount of E6000 glue on the back of the metal, making sure that the glue was close to all the corners and edges, and then glued it to the cardboard that had been the backing for the original print. I piled big books on the metal hoping that the weight would help everything adhere better.

After the glue was dry, I put the metal in the frame and secured it with glazing points.


And here you go!







No comments :

Post a Comment